Industrial Grade USB to CAN FD Adapter CAN CAN FD Bus Communicate Interface Convertor CAN CAN FD Protocol Data Analyzer Item Type: Industrial Grade USB to CAN FD Adapter Material: Aluminum Alloy USB Interface: 5V (Direct Power Supply Via USB Port, No Additional Power Supply Required) CAN/CAN FD Interface: Number of CAN/CAN FD Channels: Two: CAN1 and CAN2 (Independent and Unaffected, Fully Isolated, Isolation Voltage 3000V DC) Interface: Terminal (OPEN6 Pitch 5.08mm) Matching Resistors: Two 120Ω Termination Resistors Are Built In for Each CAN/CAN FD, Which Can Be Enabled by a Switch. Communicate Rate: 100Kbps to 5Mbps (Configurable via Software) Protocol Support: CAN2.0A and 2.0B, ISO 11898 1 CAN FD Protocol Specification V.1.0 Protocols Data Transceiver Capacity: 20000 frames/sec for Each CAN/CAN FD Receive, 5000 frames/sec for Each CAN/CAN FD Transmit Data Transceiver Buffer: 1500 Frames Per CAN/CAN FDReceive Buffer, 64 Frames PerCAN/CAN FD Transmit Buffer (Automatic Retransmission in Case of Transmission Failure) Indicator Light: WR: Power Indicator SYS: System Status Indicator, Normally Off; When There Is an Error on the Bus, It Is Always On. CAN1: CAN1 Channel Indicator (Blinking When Sending and Receiving Data) CAN2: CAN2 Channel Indicator (Blinking When Sending and Receiving Data) Supported Systems: For Windows XP/7/8/10/11 (32bit and 64bit), Not Supported for Linux Systems. Size: Approx. 96 x 104 x 70 x 25mm / 3.8 x 4.1 x 2.8 x 1.0in