This is a DIY heat repair rhinestone applicator to make shiny rhinestones for your items. Small size, easy to carry. The non-slip handle design is very user-friendly, giving you a comfortable experience. The ergonomic handle makes it easy to use. Comes with a safety stand and 7 different applicator tips for applying heat-set crystals of different sizes. You have different uses at any time. Preheating takes only 2-3 minutes, easy to use. Built-in thermostat, no need to adjust temperature. With switch, easy to control and operate. Application: Works with all flat fabric materials, works with most types of crystals/rivets/beads. Product Description Technical Specifications: Material: ABS Shell Purple Instructions: 1. Insert the applicator and open. Hold for 2 minutes. 2. Put the point with the stone on the stone and pick it up. 3. Watch the glue until it is wet and shiny. Now you can apply the stone to the surface. Depending on the size of the rhinestone, it may take about 5 seconds or more. 4. Gently push the applicator toward the surface at a 90-degree angle. Move the applicator up and away. If the stone is stuck on the tip, use tweezers to push it down into the groove of the tip to remove the stone. 5. If the stone is not glued properly, place the end cap on the stone for a few seconds to melt the glue again. Scope of supply: 1 x Rhinestone Applicator 1 x Holder 7 x Interchangeable Precision Tips