Random Color Mini Sewing Machine Portable Handmade Sewing Machine Material: plastic Color: Random  Size: about 11X7X4CM / 4.33X2.75X1.57 IN Proper use: ： 1. Holding the machine: Hold the base with your four fingers with your right hand, and place your thumb on the top of the body to hold the machine smoothly. Zh 2. Threading: Pull the thread on the spool gently. Pass the lead coil again. The threaded lead is temporarily placed next to the needle, and the threader is passed through the needle hole from the front of the needle (to the fuselage joint), then the thread is introduced into the small hole of the threader, and the thread is pulled out of the threader to pull out the thread about 2 -3 cm pressure plate is ready e. Zh 3. Put the cloth: Use the index finger of your right hand to lift the platen, place the fabric ready to be sewn (thickness not more than 0 mm) flatly under the platen, and gently put the platen back to hold the fabric; 4. Sewing operation: hold the fabric with your left hand, gently press the top thumb of the right hand to the bottom of the upper cover, and then press the thumb down again. In this way, the cloth feeding mechanism will automatically feed the sewing material to the left. Hold the right hand of the machine and gradually move it to the right. The left hand will gently move the sewing material to the left in accordance with the sewing rhythm until the end of sewing. Use scissors to cut the thread ends and gently pull the pressure plate to take out the fabric. From the reverse side of the stitched fabric, pull out the next thread end, make it penetrate the next section of the loop, tighten and tie a knot, and the stitches are firm; do not pull the thread by pulling the fabric at the end of sewing Head, so as not to damage the needles and pins; 5. The machine can automatically feed the fabric and adjust the tension between the pins, but pay attention to the following points: the pins are too tight, adjust the pressure nut slightly counterclockwise; the pins are too loose, adjust the pressure nut slightly clockwise; the correct The pins are tight. For larger stitches, the left hand pull can be slightly faster. If the stitches need to be denser, the left hand pull can be slower; 6. Change the string: If you use a large string, you can connect a spare extension rod to the spool shaft and put it in the large string. Put a spare plastic cap on the end of the rod to fix the large thread, then rethread the thread, adjust the tightness of the thread, and sew; use cotton or synthetic thread effect. Zh 7. Needle change: loosen the fixing screw and take out the broken needle. Install the new needle as shown, taking care to face the flat side of the needle upside down with the fixing screw, not the other way round. Miniature, manual operation, this sewing machine has the functions of automatic cloth feeding and adjusting the tightness between the stitches to achieve a professional effect;