PWM SIGNAL DO TRANSDUCER MODULE 1-3KHZ 0-10V Features: PWM converts digital signals to analog signal (from 0 do 10 V). The input digital signal can be a PWM 5 V or 24 V signal at 0-100%. Analog output signal can have a voltage of 0-10 V. Can be used do industrial control panel PLC or other switching signal interface. This module is easy do connect and convenient to use. Specification: Current: max. 12mA Input supply voltage: 12-30 V. Size: approx. 5 x 4,5 cm / 1,97 x 1,77 inches Weight: 20g Quantity: 1 piece Za method: PWM signal input frequency range: 1 KHZ-3 KHZ PWM signal input level range: From 4,5 V do 10 V from the top of the do peak level, jumper inserted at 5 V. This type of signal mainly dla conventional industrial control cards (such as MACH3 board), dla 5 V processor interface. From 12 do 24 V from the top of the do peak level, jumper inserted at 24 V. Signal of this type mainly dla conventional interface PLC Explanation of 0-10V analog voltage output: When the signal input port is not connected, the output port gives 0V. Za first time we turn on this module, we better calibrate it: find a signal with a duty cycle of 50%, connect do DIN -, DIN , the amplitude matches do corresponding jumper. When the frequency is 1 kHz 3 kHz, use the do check the AO, GND. The meter should show about 5,4V. The potentiometer on the converter module is set to show a multimeter of about 5,4V. After doing this, we calibrated and adjusted the pulse signal za using this converter module. ma definition of 0,1V. Output current 10mA. If the fill factor is opposite to do voltage, we can choose PWM output pin STEP LOW / ACTIVE dla MACH3 software. The package includes: 1 x PWM to Voltage Signal Converter After power on, when ma no input signal, the output is 0V. The output is only when there is an input.