Specification: Applicable models: for Switch, Switch OLED Input voltage: 5V Input current: 1.5A Operating temperature: -10~45°C Charging time: about 3.5 hours Product weight: 175g Packing size: about 167*135*43 mm/6.57*5.31*1.69inch Note: Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! Please allow 1-2cm measuring deviation due to manual measurement. Included: 1*Charging base 1*Instruction 1. Applicable Models: This charging dock station is suitable for Switch, Switch OLED. It can charge 4 Joy-Pads L/R small handles at the same time. 2. Connect to Switch Wired Handle: There is a USB 2.0 female port on the back of the charging base (left rear), with USB 2.0 data transmission function. When using this charging base, it does not occupy the USB 2.0 port on the original base. This port can be connected to a Switch wired handle. This product is designed with a USB 2.0 male input port, which can be plugged into the original base USB female port. 3. Multiple Protection: Adopt intelligent MCU control circuit, built-in self-recovery insurance at the input end, with over-current protection function, short-circuit protection function (output short circuit or load current greater than 1.5A to turn off the output), which effectively improves the safety performance of the charging base. 4. Charging Indication: The charger has two charging indications: red light and green light. The red light is displayed during charging, and the green light is displayed when fully charged or without a handle.