Device designed do strip insulation from wires. Presser operating range: 0,2 - 6,0 mm2 (10 - 24 AWG) multifunctional, reinforced device, has a rubberized handle and hardened blades mechanism: frontal, automatic in the process of removing insulation automatically adjusts do of the cross-section of the processed wire has an additional cutter and tip press The puller has an adjustable length of the section do isolation Length: 205 mm Weight: 0,30 kg Clamping of connector terminals: insulated: 0,5 - 6 mm2 (22-10 AWG), uninsulated: 4 - 6 mm2 (12-10 AWG), 1,5 - 2,5 mm2 (16-14 AWG), 05 - 1mm2 (22-18 AWG). HIGH QUALITY OF WORKMANSHIP AUTOMATIC INSULATION PULLER AMiO INSULATION PULLER this practical tool will allow for quick and precise removal of insulation, from single-core or multi-core wires. To remove the insulation, insert the cable into the jaws in such a way that it adheres evenly do of the tool - then squeeze the handle WIRE CUTTER - Another function of the puller is to cut wires. The 11 mm blade is located between the tool holders. To cut a wire of similar or smaller width, all you have to do is place it between the blades and squeeze it tightly. CONNECTOR TERMINAL PRASKA - the device can be za to crimp insulated and non-insulated connector terminals on wires with a cross-section of 1.5 mm2 do 6 mm2. Simply insert the conductor with the isolated tip and insert it do of the connector tip, then place it in the place intended do crimping PRESSURE ADJUSTMENT LIMITER - The device has a knob that is located under the jaws. With its help, you can adjust the pressure on the insulation, so you dont have to worry about damaging the cable during operation.