The power supply and signal are fully isolated, with stronger anti-interference ability and use!USB To RS485/422 converter allows PC users to connect their -485/422 devices to systems that use USB interface.By attaching the converter to a PC, it will no longer be necessary to open the chassis or turn off the PC to install the hub.With the converter, the user instantly gets one extra high-speed -485 or -422 ports.In addition, since the power is derived from the USB port, there are not any cumbersome power adapters. This makes the converter especially suitable for PLCs, printers, POS system and industrial .Power supply: USB 5VTransmission distance: up to 1200 meters (9600bps)Chip solution: CH340ECommunication protocol: pure hardware device, not subject to agreementBaud rate: up to 256000bps, supporting mutual transmission to support higher baud rateThe power supply and signal are completely isolated, and the anti-interference ability is strongerProtection: transient suppression protection, electrostatic ESD protection, surge protection, short AB signal line and short-circuit protection with power supply (short-circuit without burning)Temperature range: -40 C - 80 CSupport system: support hot swap, support for win98 for for 2000 for 2003 for 2008 for XP for WIN7 for WIN8 for WIN10 for VISTA for LINUX for system, USB interface can be hot swappedAutomatically identify and control the data transmission direction, without any handshake signals (such as , DTR, etc.) without jumper settings to achieve mode conversion, to compliance with the existing communication software and interface hardware.Different batches, the color of the PCB board inside the converter is random, don't accept the specified color; the computer display is different, the converter color .Colour: blueMaterial: PCB+plastic+metalSize: 70x27x13mmPackage Contents:1 * USB To RS485 RS232 ConverterOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.