Replacement motherboard / drive core for S6 robot vacuum cleaner (mounting fit) Key benefits Direct compatibility with S6: designed to match the original S6 motherboard mounting points and connector layout for a precise, secure fit. Restores core control functions: manages drive motors, sensors, cleaning routines and navigation so the vacuum returns to smooth, reliable operation. Improved reliability: uses quality components chosen to reduce electrical interference and lower the chance of failures during normal use. Simple replacement: matched interfaces and mounting make swapin replacement straightforward for technicians or experienced DIY users. What this part does Controls movement and cleaning behavior by coordinating motor outputs and sensor inputs. Regulates navigation routines so the unit follows intended cleaning paths and responds to obstacles. Provides the same physical mounting and connector layout as the original S6 board for a direct replacement. Important attributes Compatibility: specifically for S6 robot vacuum cleaner models (mounting fit and connectormatched). Function: drive/core control board responsible for cleaning and navigation control. Performance: built to maintain smooth operation and stable signal handling to reduce interruptions. Installation: plugandplay replacement when installed in the original S6 chassis using existing mounts and connectors. Typical use scenarios a failed or intermittently functioning motherboard to restore navigation and motor control after erratic behavior. damage from power surges or component failure to avoid replacing the entire robot. Used by centers or experienced owners performing routine part replacement to extend the service life of an S6 vacuum. Notes Intended as a direct replacement part for S6 models; verify model compatibility before . Installation should follow standard safety precautions (power off, disconnect battery) and may require basic tools.