Condition: 100% Brand New <br>Item Type: Handwheel <br>Material: Plastic <br>Color: As the Picture Shown <br>Encoder Specification: <br>Power Supply Voltage: DC5±10% <br>Pulse Number: 100PPR <br>Output Voltage (VH) (Maximum): ≥3.8V <br>Output Voltage (VL) (Minimum): ≤0.3V <br>Output Current: 80mA <br>Model Format: A.B.A-.B- <br>Output Resistance: DIFF <br>Response Speed: 5KHz <br>Current Consumption: 50mA <br>Starting Torque (Maximum): 150g <br>Axial Volume (minimum): R 2kg±10% <br>Rotation Life (minimum): 1KKR <br>Operating Temperature: 0℃/+50℃ <br>Storage Temperature: -10℃/+70℃ <br>Operating Humidity: 35-80% <br>Vibration Resistance: 0.5G <br>Heavy Strike Resistance: 2G <br>Wiring Table Specification: <br>Output Signal: A B V0 V+ A- B- <br> <br>Terminal-Line Driver A: 1 2 3 4 5 6 <br> <br>Instruction: <br>YP800-100B-1L represents a large handwheel with a diameter of 80mm, the output is 100 pulses, the working voltage is 5V, and the output mode is long-line output. This product is suitable for CNC machine tools, two orthogonal output signals (A, B), 100 pulses , The output mode is long-line drive.<br>1、High?end CNC handwheel, finely crafted, has excellent quality and good performance. <br>2、High?quality plastic material, hard, corrosion?resistant, and has long service life. <br>3、5V, 100PPR, A A? B B?, suitable for 98% of Chinese systems, to better meet your needs. <br>4、Small, compact, easy to carry and operate, can bring you more convenience. <br>5、Well?made, excellent quality, higher work efficiency, and bring you a better experience.1. The encoder is a precision instrument. It is forbidden to knock, drop, bump, etc. during installation. Improper installation or use will affect the performance and service life of the encoder. <br>2. Pay attention to the shaft load of the encoder during installation, and must not exceed the limit load. <br>3. Be careful not to exceed the limit speed of the encoder during use. If the speed exceeds the limit, the electrical signal of the encoder may be lost. <br>4. The wiring must be correct. If the wiring error will cause damage to the internal circuit of the encoder, the unused cable shall be insulated before the initial starting. <br>5. Maximum response frequency limited maximum speed.1 x Handwheel<div>1 x Instruction</div><div>3 x Terminal</div>