P2040-1.14LCD is a high-performance Development board , Integrated 1.14 inch LCD (240x135 resolution, IPS screen, 65K RGB colors). with flexible digital interfaces. It incorporates 's RP2040 microcontroller chip. The RP2040 features a dual-core ArmCortex-M0+ processor clocked at 133MHz with 264KB internal SRAM and 2MB internal flash storage. Inside the RP2040 is a 'permanent ROM' USB UF2 bootloader. What that means is when you want to program new firmware, you can hold down the BOOTSEL button while plugging it into USB (or pulling down the RUN/Reset pin to ground) and it will appear as a USB disk drive you can drag the firmware onto. There is great C/C++ support, unofficial (but really good) for Arduinosupport, You can also use micropthon and circuitpython. Features: Lora module: With SX1278(410-525MHz,+18dBm),If you select the sx127x module version, the SD card read / write function will not be supported Size: 51.5 x 25 mm RP2040 32-bit M0+ dual core running at ~125 MHz @ 3.3Vlogic and power 264 KB RAM 2 MB SPI FLASH chip for storing files and CircuitPython/MicroPython code storage. No EEPROM Four 12 bit ADCs ( than Pico) Two I2C, Two SPI and two UART peripherals Integrated 1.14 inch LCD Two user buttons(IO0,IO1) Both Reset button and Bootloader select button for quick restarts (no unplugging-replugging to relaunch code) Integrated SD Card Connector Pin 14 general blue LED flashing 3.3V power indicator LED Built in li- charger with charging status indicator LED Optional SWD debug port can be soldered in for debug access 3.3V regulator with 500mA current output USB Type C connector lets you access built-in ROM USB bootloader and serial port debugging. Material: PCB colour: pink Package Contents: 1 x RP2040 Development Board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.