100% brand new and high quality Features: The Raspberry Pi Build HAT fits any Raspberry Pi with a 40-pin GPIO header and lets you control up to four LEGO- Technic motors and sensors from the LEGO- Education SPIKE Portfolio, a flexible system with unlimited possibilities. Onboard Raspberry Pi RP2040 microcontroller manages low-level control of LEGO- Technic devices. Onboard 4x LPF2 connectors for LEGO- Technic motors and sensors. Raspberry Pi 40PIN GPIO interface. With external 8V power supply, allows powering your Raspberry Pi (except Raspberry Pi 400, cause it can't be powered via GPIO) and all connected devices. Specifications: Output Voltage: +8.0V DC Load valley current: 0.01A Rated load current: 6.0A Peak power: 48.0W Load Regulation: 5% Line regulation: 5% Ripple and Noise: 200mVp-p Rise time: DC output regulation limit peak value 100ms Turn-on delay: 3000ms peak at nominal input AC voltage Protection: Short circuit protection (overcurrent protection/overvoltage protection) Efficiency: Valley 87,77% (output current from 100%, 75% to 100%, 50%, 25%) Cable Specification: 1.5m 16AWG Output Connector: Barrel Connector Size: approx. 5.5x2.1x11mm center Voltage range: 100-240Vac (rated) 96-264Vac (operating voltage) Frequency: 50/60HZ3Hz Current: Peak 1.2A Power consumption (no load): peak 0.1W Inrush current: no damage, input fuse does not blow Size: approx. 65x56.5mm/2.56x2.22in Note: Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid. Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! Package Includes: 1 x Raspberry Pi Build HAT