Made of materials, sturdy and durable. BEC 9V or 12V output,Designed for Video mitter, Camera, Gimbal ect BEC 5V output,Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed BEC Vx output,Designed for Servos MCU: STM32F405RGT6, 168MHz , 1MB Flash IMU: ICM42688-P Baro: DPS310 OSD: AT7456E Blackbox: Micro-SD card slot 6x UARTs, 1x Softserial_Tx option(INAV) 10x PWM outputs 2x I2C 3x ADC (VBAT, Current, RSSI) Built in inverter for SBUS input USB Type-C(USB2.0) FC Firmware ArduPilot: MatekF405-Wing (ArduPlane 4.4 or newer) INAV: MATEKF405SE (INAV 6.0 or newer) PDB Input voltage range: 9-30V (3-6S LiPo) w or TVS protection Current Senor: 220A, 3.3V ADC (INAV scale 150, ArduPilot 66.7A or V) Sense resistor: 100A continuous, 220A peak Battery Voltage divider 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot) BEC 5V output Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed Continuous current: 2 Amps BEC 9V or 12V output Designed for Video mitter, Camera, Gimbal ect. Continuous current: 2 Amps 12V option with Jumper pad for stable 9V or 12V output, input voltage should Greater than output voltage and1V BEC Vx output BEC 3.3V output Designed for external 3.3V peripherals Linear Regulator Continuous current: 200mA (Due to different batches, the printed words on the product will be different, which does not affect use) Material: PCB colour: Blue Package Contents: 1 x F405-Wing-V2 1 x 20cm JST-GH-4P to JST-GH-4P Cable 1 Set x Dupont 2.54 Pins (Board is shipped unsoldered) Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the rea