Electronic Load Quitation Detector Module DC 12V Battery Capacity Detector 0-10A Digital Battery Power Meter 100W Feature: 1. Wide Range of Constant Discharge Current: The battery capacity tester offers a constant discharge current range of 0-10A (for the entire device), allowing you to test batteries of various capacities effectively. 2. Single-Mode Constant Current Operation: With its single-mode constant current (CC) configuration, this battery detector module ensures consistent and accurate discharge current throughout the testing process. You can rely on precise and reliable results. 3. Minimal Error in Maximum Discharge Current: The digital battery tester boasts an impressively low maximum discharge current error, with only 0.7% or up to 0.01A deviation. This high level of accuracy guarantees precise measurements. 4. Minimal Error in Capacity Testing: When it comes to capacity testing, this battery capacity detector minimizes errors significantly. With maximum errors of just 2.5% at 0.5A, 1.5% at 2A, and 1.2% for 5A and higher, you can trust the precision of the readings. 5. Reliable Performance for Accurate Battery Assessment: The digital battery power meter provides reliable performance, ensuring accurate assessment of battery capacity. With its advanced features and dependable operation, you can make informed decisions about your batteries. Specification: Certification: NONE Origin: Mainland China DIY Supplies: ELECTRICAL Type: Electronic Device Battery Tester Model Number: Battery Capacity Tester Power supply: DC12V5% Fan current: 0.72A Constant discharge current range: 0-10A (whole machine) Operating mode: Single mode constant current (CC) Maximum discharge current Error: 0.7% - 0.01A Max. Capacity test error: 0.5A 2.5%, 2A 1.5%, 5A and above 1.2% Max. Power: 100W Input connector: 5.5x2.5mm Product size: 110 x 80 x 60mm/4.3 x 3.1 x 2.4inch Operating instructions: Connect the DC 12V power supply, enter the electronic load mode, make sure it is in the stop state and connect the power supply under test to the test input port. Please note the correct polarity of the connection! Set the constant current via the knob. Note: As it is open work, there is no voltage and power limit, but normal operation should be below 100V and 100W Note: Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you! Please allow 1-2cm measuring deviation due to manual measurement. 1 xBattery Capacity Tester