DSO Oscilloscope Fully Assembled with bnc-clip Cable Probe 1MSa/s 0-200KHz Sensitivity 5mV/div EU/USA StandardOOTDTYCootdtyFeatures:This digital oscilloscope kit adopts ARM Cortex-M3 CPU and 2.4 inch TFT monitor and protective case. Used for secondary development based on this set, for example, it can be changed to Millivoltmeter, data loggers. With auto/normal/single trigger modes, easy to capture the momentum wave. With digital display of waveform parameters, including frequency, period, pulse width, operating ratio, MAX./MIN./AVG./Peak-Peak/virtual values. Short circuit and open circuit detection: it can help the user to find the soldering error. Observable previous run before the trigger (negative delay). Lock the waveform display at any time (HOLD function). Come with instructions, easy to install and operate. Specification:Material: ABS + Metal Size: 115x7 5mm/4.53x2.95inReal-time Maximum Sampling Rate: 1MSa/sAnalog Bandwidth: 0-200KHzSensitivity Range: 5mV/div-20mV/idvMaximum Input Voltage: 50Vpk (1X Probe)Input Impedance: 1M ohms/20pF, You Can Mention Them: 12 bitRecord Length: 1024 PointsCoupling Modes: DC/AC/GNDequestr Base Range: 500s/Div - 10us/DivTrigger Modes: Auto, Normal & SingleTrigger Position: Buffer CenterVoltage Power Supply: DC 9V(8-10V)Current Consumption: - 120mA 9VRmainboard Size: 94x65mm / 3.7x2.56 inchAnalog Board Size: 65x47mm / 2.56x1.85 inchScreen Size: 52x40mm / 2x1.57 inchPackage Included:1x Digital Oscilloscope1x BNC Clip1x English ManualNote: Please allow 1-3cm error due to manual measurement. Pls make sure you don't mind before you bid. Due to the difference between different monitors, the picture may not reflect the actual color of the item