Dual-channel H-bridge driver working mode creates higher working efficiency. L298N as main chip. Can drive one 2-phase stepper motor, one 4-phase stepper motor, or two DC motors. To avoid damage to the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. Equipped with large-capacity filter capacitors and freewheeling protection diodes to increase reliability. Maximum working voltage up to 46V, peak current up to 3A, continuous current 2A, maximum power 25W. Features large capacity filter capacitance and freewheeling protection diode for improved stability and reliability. Specification: Chip: L298N Logic voltage: 5V Logic current: 0mA–36mA Maximum power: 25W Drive voltage: 5V–35V Drive current: 2A (for each DC motor) Operating mode: Dual H-bridge driver (can drive 2 DC motors) Reason 1: Uses L298N as Main Chip The L298N is a high-voltage, high-current motor driver IC. It features high operating voltage (up to 46V), large output current (up to 3A peak), continuous current of 2A, and rated power of 25W. The chip comes in a 15-pin package. Two built-in H-bridge drivers enable control of DC motors, stepper motors, relay coils, and similar loads. The chip supports connection to an external sensing resistor to provide feedback to the control circuit. Compatible with standard logic level signals and includes two enable control terminals. Allows internal logic circuits to operate at low voltage independently from input signals. Reason 2: Wide Application Size: 43 x 43 x 27mm Material: PCB Color: Red Package Contents: 2 x L298N Motor Drive Controller Board Module Note: Light reflection and differences in display screens may cause slight variations between the color of the item in the image and the actual product. Measurement allows an error of +/- 1–3cm.