Feature:1. 4u active CPU cooler for X9 slot R R 4U cooler LGA2011 square and narrow ILM for Xeon 3800 RPM.2. Support for Intel Xeon processor E51600/E51600 v2/E51600 v3 series.3. Support for Intel Xeon processor E52600/E52600 v2/E52600 v3 /E52600 v4 series.4. Can effectively reduce temperature generated by the CPU during operation and prolong the service life of computer.5. The fan rated speed is 3800RPM, low noise, stable and reliable performance.Specification:Item Type: CPU Cooler Fan.Model: SNK-P0050AP4Type: RadiatorILM Type: square, narrowCPU Radiator Size: Approx. 105 x 93 x 126mm / 4.1 x 3.7 x 5inApplication: 4U X9 UP DP serverSocket Type: LGA 2011Supported CPU: For Intel Xeon processor E5-1600/E5-1600 v2/E5-1600 v3 series, For Intel Xeon processor E5-2600/E5-2600 v2/E5-2600 v3 /E5-2600 v4 seriesSupported CPU TDP: Up to 165 wattsCooling Fan:Speed Control: 4Pin PWMRated Voltage: 12.0 VDCRated Speed: 3,800 RPMNoise: 38.0 dB (A) at rated speedCooling Fan Size: Approx. 92 x 92 x 25mm / 3.6 x 3.6 x 1inLocation: FrontHow To Use:1. Take out SNK-P0050AP4 from the package. SNK. poo50AP4 supports for Intel Socket LGA2011 (SocketR) square and narrow independent loading mechanism (ILM). Before installing the heat sink, please check which ILM is equipped on the motherboard.2. By default, the square ILM mounting bracket is fixed on the bottom of the radiator. If the motherboard is equipped with a narrow ILM, follow the instructions in Figure 1 to replace the default square ILM mounting bracket with a narrow ILM mounting bracket.3. Remove the protective cover of the thermal interface material (TIM). The required amount has been pre-applied on the bottom of the heat sink. Check the pre-coated TIM for damage.4. Place the heat sink directly on the top of the CPU so that the four heat sink mounting screws are aligned with the four heat sink mounting studs on the lLM and fixed on them. The radiator must be correctly aligned with the flowing direction of the system cooling air. Please note that when tightening the four radiator mounting screws, do not install the radiator cooling fan on the radiator body.5. Use a screwdriver with cross #2 screw head and adjust the torsion setting of the screwdriver to 5.0 kgf-cm (4.3lbf-in). Before opening the screwdriver, make sure that the screwdriver bit is fully inserted into the cross groove on the heat sink mounting screw head. During the installation process, keep the heat sink mounting screws vertical.6. Tighten the two diagonal radiator mounting screws until they are just right. Do not tighten completely! Then, do the same with the remaining two diagonal heat sink mounting screws.7. Follow the cross installation pattern on all four heat sink mounting screws to ensure that the bottom of the heat sink is properly installed on the CPU and prevent the heat sink from tilting. Fully tighten all four heat sink mounting screws to complete the installation.8. Install the radiator cooling fan and bracket assembly to the radiator body, and then tighten the single locking screw on the top of the fan bracket9. Connect the SNK-PO050AP4 cooling fan connector to the fan header marked CPU on the motherboard.Package List:1 x Cooling Base1 x Cooling Fan1 x User Manual