Features Control 2 motors: can enter 2 different pulses, steering and activate control signals at the same time to control 2 different motors without interference with each other. STANDARD WIRING The motor wiring uses standard 2.54MM plugs, the flat cable uses a single 24AWG PH-head wire, the length is 300MM and the signal wiring uses 26AWG wire. WIDE APPLICATIONS: Widely used in automation equipment, such as 3D printers, engraving machines, laser machines, packaging equipment, automated production lines, etc. CONDUCTOR AND WIRING: Composed of driver and wiring, and integrates the functions of 2 general 2-phase stepper drivers into a driver box, saving space and wiring. APPLICABLE ENGINE: The subdivision number of each engine is a multiple of 2, which can be adapted to 57, 42, 39, 28, 24, etc. 2-phase stepper motors less than 2A. Specification: Item Type: Stepper Motor Driver Model No.: SMD-1524-M32S-TV10 Specification: 4phase and 5wire single-pole type Fast response rate: 100KHz Operating temperature: 0-50°C Operating Humidity: 40-90%RH Input voltage: DC10V-26V. Input current: >5A Allowable Input Power Ripple:≤50MV 1. Wiring Method: GND: DC power ground wire +V: DC power supply positive pole, 10V-26V range, recommended value +24VDC A+, A-: A phase coil of the motor B+, B-: motor B-phase coil VM: motor coil power pin, which is connected to the V+ pin in the positive direction Package list: 1 x Stepper Motor Driver Small note: Do not place it next to other heat-generating equipment, avoid dust, oil mist, corrosive gases, places with high humidity and strong vibration, and prohibit flammable gases and conductive dust. Package List 1 x Stepper Motor Driver