To achieve fast turn- the circuit, an number of switching; Conducting and cutting process does not noise, no , no electromagnetic interference; Compared with electromagnetic relay , lifeThe dual-MOS parallel drive, lower resistance, more current, strong power; at room temperature, operating current of up to 15A, power up to 400W, to meet the most use of the equipment; A for controlling the motor, lights, LED, DC motors, -pumps, solenoid valves, etc., very convenient.Wide voltage input (5 ~ 36V), most devices can be used, very convenient; The interface is clear and simple, , easy to understand, meet all your needs. The emergency stop function ("STOP" key);With reverse polarity protection, reverse polarity will not burn the product.Increase the sleep mode, if this mode is enabled, without any operation within 5 minutes, then automatically turn off the monitor, any key ; You can set a different OP, , parameters, which are of each other, and are automatically saved. After the module is powered down, all parameter settings are not lost.Product parameters: 1: Operating voltage: 5--36V. 2: Trigger Source: Active-high (3.0V-24V), have optocoupler isolation, can the system's anti-jamming capability (customers can also shorting common ground). 3: Output capacity: DC 5V - 36V, at room temperature, continuous current 15A, power 400W Enhance heat dissipation conditions, the maximum current up to 30A.4: Quiescent Current: 20mA; Operating Current: 50mA5: Life: any switching ; Working temperature: -40-85; Size: 6.0 x 3.4 x 1.2cm.6: With optocoupler isolation, enhanced anti-jamming capability.Operating mode:P1: trigger signal, the relay is on "OP" time, and then disconnect; in the "OP" time, as follows:P1.1:signal is triggered again, invalidP1.2: signal is triggered again, the clock is resetP1.3: Signal trigger again, relay off, stop the clockP-2: trigger signal, the relay off "" of time, the relay on "OP" time, and then disconnect relayP3.1: trigger signal, the relay is turned on after the "OP" time, the relay off "" time, then the operation , if the trigger signal period, the relay off, stop the clock; the number of cycles ( " ") can be set.P3.2: without triggering signal, the relay is on "OP" time, the relay off "" time, and has been cycling; frequency ( "") can be setP-4: signal holding function. If there is a trigger signal timing is cleared, the relay remains on; when the signal disappears, after the timing "OP" time, the relay is; if another signal during timing, timing is clearedCondition:NewType: ICscolor:BlueMaterial:plasticPackage Contents:2 x Digital Time Delay RelayOnly the above package content, other are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.