16 Channels Radio Wireless Remote Flash Trigger

The remote trigger for studio flashes and outdoor flash is used as the controller of synchronous trigger studio flash of cameras. It consists of a signal sender and a receiver trigger and works by mns of the frequency modulation wireless remote control. hot shoe interface, compatible with NaCanon, , , , , etc. Globally univeral 43300CMhz frequency, 16 channels. With studio flash interface, can trigger several kinds of studio flashes. Transmitting distance up to 30M, no limits with directions or angles. 1/4\" nut design to be connected with tripod for stable flashlight. frequency regulation, convinient for photographers to shoot. Energy-saving design with 12V 23A battery of transmitter and 2 batteries(not included) of receiver. Comes with a PC sync cord for cameras without hot shoe socket. 16 Channels Radio Wireless Remote Flash Trigger for NaCanon PT-16GY Introduction The remote trigger for studio flashes and outdoor flash is used as the controller of synchronous trigger studio flash of cameras. It consists of a signal sender and a receiver trigger and works by mns of the frequency modulation wireless remote control. The signal transmitter adopts the advanced circuit and components, and can transmit the coded FM wireless signal. The circuit of the transmitter has the function of standby and hibernation, thus it has low power consumption; the products under the standby mode for more than one yr with NaOnly one battery; continuously trigger for thirty thousand times. The trigger current is NaOnly 0.01MA, which will definitely cause no damage to the flash contact of the camera. The transmitter is applicable to the traditional or digital camera with hot shoe or PC controlling interface. Receiver trigger adopts dry battery for power supply, which is safe, energy-saving, and convenient. The product adopts -computer for controlling the decoding, Which has anti-interference capability; sensitive rction speed, the highest synchronous speed can rch 1/250sec. All the of the product uniquely have the multi-frequency isolation and the self coding matching function by users. Users can freely match and use the sender and the receiver according to the demands, which have 16 isolated channels to suit for specific shooting environments. Triggers set in different channels can be combined to work or independently work but do not interfere with ch other in an efficient distance. Ftures: hot shoe interface, compatible with NaCanon, , , , , etc. Globally univeral 43300CMhz frequency, 16 channels. With studio flash interface, can trigger several kinds of studio flashes. Transmitting distance up to 30M, no limits with directions or angles. 1/4" nut design to be connected with tripod for stable flashlight. frequency regulation, convinient for photographers to shoot. Energy-saving design with 12V 23A battery of transmitter and 2 batteries(not included) of receiver. Comes with a PC sync cord for cameras without hot shoe socket. Note: This trigger do not support TTL function. How to use: 1. Insert the transmitter's hot shoe socket into your camera's hot shoe , plug the flash onto the receiver, ON the receiver. Make sure the channel NaSelector of both transmitter and receiver at same channel. Press the Test button on the transmitter to test before shooting. 2. If your camera has not hot shoe socket for connecting the transmitter you can connect the transmitter to the camera by the PC Sync Cord provided. (NaOnly the old camera needed). 3. You can trigger both the flashgun and with this flash trigger. If you use the receiver on NaBig studio strobe flashlight or AC slave flash, you can just connect the receiver to the studio strobe flashlight with 3.5mm or 6.35mm plug PC Sync cord(not included). Compatible with: * NaCanon II, , 550 , 540EZ, 520EZ, 430E