12/24V generators Wind charge controller 800W MPPT

Wind Generator Controller 12/24V 800W MPPT Wind Charge Controller Wind Turbine Generator Controller<br> Wind charge controller 800W MPPT for 12/24V generators<br> 1.<br> Automatically charge the battery.<br> 2.<br> The rectifier and brake circuit of this controller adopts an integrated module, which is more advanced than the traditional terms of heat dissipation and reliability.<br> 3.<br> Adopts a fully sealed and waterproof design, and its protection grade reaches above IP67.<br> It can be used normally for a long time even in water.<br> Notes: Confirm that the output voltage of the wind turbine generator is consistent with the rating voltage of the battery.<br> Connect the wires in the following order, first connect the positive and negative poles of the battery, and then connect the three-phase voltage output of the fan.<br> Please connect the battery and wind turbine to the controller in accordance with the instructions.<br> Reverse polarity or wrong position will lead to abnormal operation of the system or even complete damage to the controller.<br> Wiring mode:<br> 1.<br> Connect the positive and negative poles of the battery to the positive (red) and negative (black) terminals of the battery of the controller.<br> 2.<br> Respectively connect the three-phase output voltage of the wind turbine to the three-phase input (green line) terminal of the controller fan.<br> Parameters:<br> 1.<br> Maximum input AC voltage: AC35V<br> 2.<br> Output voltage: 12V / 24V<br> 3.<br> Battery charging cut-off voltage: 14.5V 0.3V / 29V 0.3V<br> 4.<br> Maximum charging current: 15A (12V) maximum charging current: 10A (24V)<br> 5.<br> Wind generator speed limit voltage 14.5V 0.3V, 29V 0.3V<br> 6.<br> Protection level: IP67<br> 7.<br> Static power consumption: 0.008A<br> 8.<br> Bearing power: 800W<br> 9.<br> Maximum bearing wind speed: .12<br> 10.<br> Working temperature: -35 C - 65 C<br> 11.<br> Input wiring: three-wire system<br> 12.<br> Control mode: 12V/24V compatible<br> 13.<br> Installation : bolted<br> 14.<br> Do not reverse the positive and negativepoles to avoid burning the controller.<br> Application:Wind Controller<br> Colour: Blue<br> Material:aluminum alloy<br> Included in the package:<br> 1 x MPPT Wind Generator Controller<br> Only the listed package contents are included.<br> Note: Actual colour may vary slightly because of lighting and display settings.<br> Please allow a measurement tolerance of +/- 1-3cm.