product description:Module interface description:1. VM: The supply of module is input according to the parameters of the motor, and the measured range is 7.6~40V2. VCC: to 5V input, do not input 3.3V, otherwise it will affect the performance3. GND: is the ground pinColor: greenMaterial: PCB+MetalControl example (when the above 3 pins are connected)Task 1: A motor rotates forward with a duty cycle of 50%Solution: 2 lines of motor A are connected to AOUT1, AOUT2, AIN1 respectively, connected to low level, AIN2 is connected to 50% PWMOTask 2: B motor reverse, duty cycle 20%Solution: The two wires of motor B are connected to BOUT1 and BOUT2 respectively. BIN1 is connected to high level, BIN2 is connected to 20% PWM(If your PWM frequency is relatively high, such as 10KHz, you need 2 PWM pins to control the forward and reverse . If you 's default PWM frequency of 500HZ. You can a 10 and a PWM pin to control the forward and reverse , But the effect is not as good as 2 PWM pins)Specification:Function: It can control the forward and reverse of 2 motors (for example, only one of this module is needed for a balance car) Voltage: 7.6~40VCurrent: The module has current limiting protection, 2A (overcurrent will not off, only limit the maximum output currentControl: 4 PWM pins are required, (if inversion is not required, only 2 PWM pins are required) It is much simpler to than 298Product size: 23 x 18.3mmLead out: 2 rows of 7pin pin headersSpacing: 20mmPackage Contents:2 x motor driver moduleOnly the above package content, other products are not included.Note: Light and different displays may the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.